HMB-TEC® Alarm Clock with Remote Power Control
This alarm clock is more than all previously available! This alarm clock has real alarm outputs for sprucing up your devices, such as can turn on your automatic coffee maker, the "sunrise wakeup lamp" or Mac or PC and your stereo equipment to the alarm. Up to four electrical devices can use a 433MHz radio on or off.
Operation is intuitive and easy. The alert or alarm time can be setup by tapping on the corresponding digit of the 4-digit alarm time display. This changes the value to each one, and this is one place on a continuous basis and then starts up again from zero.
Now select the radio outlets that you want to turn the alarm time, tap the ON / OFF switch, so that the pointing upwards. next to the alarm indicator is another toggle switch. To activate the alarm, you must also turn this switch to ON. Now connect the required electrical wireless outlets and turn it on. Compare again the current time displayed on the analog display.
By means of the slider located below the analog clock you can adjust the display brightness of your iP / iPT according to your wishes. But please do not turn the iP/iPT off, otherwise there is no alarm!
Important Note:
For the operation of the application as a real power switching timeswitch alarm clock for external appliances, you need the following additional hardware:
1. 433MHz transmitter adapter available for connection to the headphone connector (at www.HMB-tec.de)
2. 433MHz Power plugs in the required number (max. 4) (available at www.HMB-tec.de as a complete set)
If you run the app without the necessary hardware, it is an awful sound in case of alarm beep. It is about the audible data stream that drives the 433MHz transmitter connected to the headphone connector.
Disclaimer:
The author guarantees the proper operation of the system assumes no liability for damages arising from its use.
For your question, we are at your disposal
HMB | TEC
Bad Homburg
www.hmb-tec.de
[email protected]